Standing seam and metal panel roofing, roof repair and full replacement in Gypsum. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Gypsum.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
A replacement is a big spend and it should feel orderly. We schedule around dry weather, work in the right order, and never leave a house open overnight.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
Buying, selling, or just want to know how many years you have left? We look, we tell you, and we do not turn it into a pitch for a roof you do not need.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Gypsum homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Gypsum home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Gypsum homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
If your roof needs a repair and not a replacement, we say so. Plenty of our best customers are people we talked out of a job they did not need yet.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
The questions that come up on just about every estimate we write.
For most Gypsum homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
We do. After a storm we photograph the damage on your Gypsum roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
A typical Gypsum shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
That is most of what leak work is. Water runs along decking and rafters before it ever drips, so the stain on your Gypsum ceiling is rarely under the actual hole. We work back to the real entry point, fix that, and check the rest of the roof while we are up there.
Sometimes. If the decking is sound and there is only one layer of shingles, a Gypsum metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Gypsum houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Real feedback from homeowners whose roofs we have worked on.
"Nice work on the roof and good communication throughout. I would have liked a little more warning about the dumpster arriving, but that is a small thing."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Roof on our shop building. They worked Saturdays so we did not have to shut the doors during the week."
Our crews cover the surrounding area, not only the city limits.